So from the info I read at OCZ forums, I have to set my memory from the default 5-5-5-15 to 4-4-4-15, and also set the memory voltage to 2.1v
I'm new to this, so I did some research and from what I gathered 4-4-4-15 means:
tCL (CAS latency) = 4
tRCD (RAS to CAS) = 4
tRP (RAS precharge) = 4
tRAS (cycle time) = 15
Is that correct?
Thanks.
Setting Memory Timings Manually
In my instance I'm not overclocking it. The ram I purchased it rated for these timings, but it requires an increased voltage so I have to set it manually. At least, that's how I understand it.
As far as performance, I would assume there is an improvement, but of how much I'm not sure.
As far as performance, I would assume there is an improvement, but of how much I'm not sure.
Cheers, Damnidge